August 24, 2000
“I wanted to share the new HeatMAX test result with you! I started the test at 5:pm. At 7:pm, I recorded the temperature of the test flame in its enclosure. Over 5 minutes the highest reading was 161.4 F. Then, with the same flame burning, I installed the new HeatMAX and walked away for another 2 hours. At 9:pm I recorded the temperature over the next 5 minutes. The highest reading was 225.8 F. An increase of 64.4 degrees F ! That converts to an increase in HEAT per unit to 39.9% !”
- A Message from Dr. Robert Kane

"We have tried said system on our steam boilers, which are operating with fuel oil, under the supervision of our factory Engineering Department." "Saving percentage is 19%."
- Director General, Engineering Shamsi Textile Industrie

"In addition to above; utilization of HeatMAX (FuelMAX) extends life of boilers by means of removing carbon residues inside boiler incinerator and flame pipes thus reducing the need for periodic maintenance. " The factory Engineering Department recommends utilization of this system with all factory boilers, vehicles, and engines."
- Director General, Engineering Shamsi Textile Industrie